10 months ago
since most of the configuration of openclaw is using terminal, lacking terminal is a huge drawback when people want to deploy openclaw on your system
3 Replies
10 months ago
You can access a terminal in your running container using the Railway CLI - install it, run railway login, then use railway ssh to get shell access. You can also right-click any service in the dashboard and select "Copy SSH Command" to get a ready-to-use command.
Status changed to Awaiting User Response Railway • 10 months ago
angelo-railway
You can access a terminal in your running container using the [Railway CLI](https://docs.railway.com/guides/cli) \- install it, run `railway login`, then use `railway ssh` to get shell access. You can also right-click any service in the dashboard and select "Copy SSH Command" to get a ready-to-use command.
10 months ago
yes, i can run the shell now. but, there is still an issue, which is that i can't do the normal config as it were deployed on my local machine or remote codespaces
Status changed to Awaiting Railway Response Railway • 10 months ago
10 months ago
This thread has been marked as public for community involvement, as it does not contain any sensitive or personal information. Any further activity in this thread will be visible to everyone.
Status changed to Open Railway • 10 months ago
a month ago
The shell itself is only part of the setup. On Railway, any OpenClaw config/workspace written outside a mounted volume is container-local and can disappear on redeploy, which is why it does not behave like a local machine or Codespace.
The supported Railway layout is:
- Attach a Railway Volume mounted at
/data. - Set these service Variables:
OPENCLAW_GATEWAY_PORT=8080OPENCLAW_GATEWAY_TOKEN=<a strong secret>OPENCLAW_STATE_DIR=/data/.openclawOPENCLAW_WORKSPACE_DIR=/data/workspace
- Redeploy once so both the Gateway and CLI resolve the same persistent paths.
- Use the web Control UI at
https://<your-domain>/openclawfor normal configuration, or SSH and runopenclaw onboard/openclaw configurewhen an interactive CLI is required. - Verify the active deployment with the read-only check
openclaw doctor --jsonandopenclaw config file --json. The reported config/state paths should be under/data, not the image filesystem.
Also check that OPENCLAW_CONFIG_READONLY=1 or OPENCLAW_NIX_MODE=1 is not set if you expect CLI config writes; either setting intentionally blocks mutation. If it is set, edit configuration through the deployment source/environment instead.
After the paths are corrected, export a backup before larger changes with openclaw backup create.
AI assistance disclosure: I used AI to structure this response and verified the commands and Railway paths against the current official OpenClaw Railway and config documentation.